Although interior house paints can be purchased in pint-size samples or five-gallon buckets, the standard measurement is by the gallon can. A gallon can of basic water-based paint can be found on store shelves for less than $25, but the additional cost of a primer coat should be considered. One-coat paint/primer blends for most DIY projects should cost between $30 and $60 a gallon, including customized tinting. VOC levels should be lower as well. For high-end painting projects featuring designer colors or full-gloss finishes, expect to pay $60 or more per gallon.
The Cutters. Someone with meticulous attention to detail and a steady hand should be assigned the job of "cutting in," or painting a straight edge where needed, such as along a wall where the ceiling does not get painted. Many products are available to assist, but none work as well as a person who's good at doing it freehand. Ensure this person is skilled (ask them to show you). A poor, jagged, wavy or splotched cutting-in job will jump out at you every time you walk by it. Why more than one cutter? This job is nerve-wracking and painful to hands and arms after a few days. You'll want to give this person a break after a few walls.
Your contractor will sweep or scrub the concrete first with a dry brush, and then clean it thoroughly with trisodium phosphate (TSP) and warm water, then let it dry. TSP is a mostly alkaline solution that does a great job cleaning grease and oil off concrete surfaces. Brush painting concrete siding costs $138 per 100 sq. ft., roll painting costs $50 per 100 sq. ft., and spray painting $32 per 100 sq. ft.
Use a roller to paint the rest of the wall. A good method to use is the 'W method'. You start by painting a large 3 foot (0.91 m) square W on the wall. Then, without lifting the roller, you fill in the W. You can paint a wall section-by-section, and do the walls one at a time for best results. It's generally a good idea to use an extension pole for your roller instead of standing on a ladder. Make sure that neither the extension pole nor the roller has plastic handles, as plastic handles are flexible and this makes it difficult to control the painting.
One of the first considerations when it comes to interior house paint is the base. There are two schools of thought, each with their pros and cons. Some brands commonly sold to contractors for commercial projects are oil-based, meaning the chosen pigment is mixed with an oil derivative called alkyd. Oil-based paint provides thorough coverage, and the finished coat resists moisture well. However, oil-based paint releases a high level of volatile organic compounds (VOCs) as it dries, and it can only be removed from floors, brushes, and clothing with strong chemical paint thinners. In fact, many states have actually banned the use of oil-based paints because of their VOC levels and hazardous ingredients.
Practicing ladder safety is key. When using an extension ladder, always test that its resting at the right angle by putting your toes against the feet of the ladder and extend your arms outwards. At the proper angle, you should be able to rest your hands on the rung in front of you comfortably. When on a ladder, you should always keep your hands free and maintain a steady center of gravity.
Expect to pay between $600 to $3,500 or $1.25 to $3 per square foot to coat vinyl, with prices likely increasing for the finish. It is one of the more inexpensive siding materials to have repainted, especially with recent innovations in materials. Changing the finish on your siding is not recommended unless it's completely degraded and worn away by the weather. You can save nearly half the vinyl siding installation cost of $4 per square foot by painting rather than replacing. Before adding a new coat to vinyl siding,