Get estimates from several contractors, request and contact references, search for complaints at the Better Business Bureau[12] and check that the company is properly bonded and insured, as well as licensed in your state[13] . Only pay a small deposit, and don't pay the entire amount until the job is finished to your complete satisfaction (both painting and cleanup).
Two aesthetic things to consider when selecting a finish are how shiny you'd like the surface to be and whether or not you want to hide any imperfections on the surface to be painted. Generally, higher-gloss paint finishes reflect light better than lower-gloss finishes, like eggshell and matte. That makes them shiny, and also causes them to highlight flaws in walls and ceilings.
Your contractor will sweep or scrub the concrete first with a dry brush, and then clean it thoroughly with trisodium phosphate (TSP) and warm water, then let it dry. TSP is a mostly alkaline solution that does a great job cleaning grease and oil off concrete surfaces. Brush painting concrete siding costs $138 per 100 sq. ft., roll painting costs $50 per 100 sq. ft., and spray painting $32 per 100 sq. ft.
Basic labor to paint home with favorable site conditions. Prep up to 3 hr per 100 SF - clean, scrape, sand and patch up to 4 defects per 100 SF. Caulk gaps and spot prime. Roll / brush 2 coats of paint over lightly textured ceiling/walls. Paint up to 2 doors and door trim per room. Includes planning, equipment and material acquisition, area preparation and protection, setup and cleanup. 129 square feet $97.99 $132.56
Compare offers. The painter offering the lowest rate may not always be the best painter for the job. Indeed, the total cost isn't the only factor to consider when choosing between multiple bids. You'll want to look at contracts side by side to ensure you're making an apples-to-apples comparison. Are the same materials being used? Are the same services included? Does the painter provide a warranty?

Use a roller to paint the rest of the wall. A good method to use is the 'W method'. You start by painting a large 3 foot (0.91 m) square W on the wall. Then, without lifting the roller, you fill in the W.[7] You can paint a wall section-by-section, and do the walls one at a time for best results. It's generally a good idea to use an extension pole for your roller instead of standing on a ladder. Make sure that neither the extension pole nor the roller has plastic handles, as plastic handles are flexible and this makes it difficult to control the painting.
Do the cleanup. When the painting is done, send the painter home and do the cleanup work yourself. This will include rolling up drop cloths and collecting scrapings, removing painter's tape (use a hair dryer on low heat to soften the adhesive), cleaning paint brushes, rollers, and other tools, replacing electric switch plates, outlet covers, and light fixtures, and sealing any leftover paint cans and storing them in a dry, temperature-controlled location.

You can expect to pay between $700 to $3,000 to paint wood siding. You’ll end up spending $1 to $3 per square foot, but typically you’ll find this material is cheaper than brick or vinyl. Wood requires some type of sealant, be it paint, stain or oil. Lumber takes well to a wide variety of coverings giving you endless options for modern, contemporary or classic looks. Some things to consider when choosing wood:
×